- Increases pH in marine and freshwater aquariums.
- May be used to increase pH in aquariums that have adequate alkalinity yet have chronically-depressed pH levels as a temporary solution.
- Composed of purified water and high purity materials.
- Made in the USA.
- Increases pH and alkalinity in marine and reef aquaria.
- Stronger than most competing products.
- Composed of purified water and ultra-high purity materials.
- Formulated by a marine scientist.
pH is a measurement of the acidity of a solution, such as aquarium water. The pH of natural seawater ranges from approximately 8.2 - 8.4, however maintaining pH in the range of 8.1 - 8.5 on a daily basis has no negative impact on captive marine organisms. To maintain stable pH within the desired range, the alkalinity should be maintained within a range of 7 - 12 dKH (2.5 - 4.3 meq/L). Aquaria with low circulation at the water’s surface, in which a CO2-injected calcium reactor is being employed, or in which a carbonate-deficient sea salt blend has been used, often have depressed pH. pH+ will bring pH in the aquarium back into the desired range.
In problem aquariums, such as those with calcium reactors, or placed in enclosed rooms with animal or human inhabitants and not enough outside air, CO2 accumulation may make raising pH above 7.8 difficult. If this product does not raise pH sufficiently, then use Boost pH+ instead of this product or in addition to this product.
Use as directed and do not exceed a pH value of 8.6, as this pH may be stressful and/or damaging to sensitive aquarium inhabitants. Additionally, changes to pH should be made very gradually, again to avoid stressing aquarium inhabitants. It is not unusual for pH to fluctuate throughout the course of 24-hours between seemingly wide-ranging values (i.e. 8.1 at night to 8.4 during the middle of the day); this is a natural occurrence that is caused by changes in the rates of photosynthesis between dark and light periods. This situation is frequently encountered in aquaria with considerable growth of macroalgae (in the display aquarium or in a refugium).
One proven method of minimizing this daily pH-fluctuation is to implement a refugium that is illuminated on an opposite schedule to the lighting for the display aquarium (known as reverse-daylight photosynthesis). In this method, the refugium is illuminated at night when the display aquarium lights are turned off, and vice versa; a 1-hour overlap of having all lights on encourages a smooth transition and little change in pH. The result is that photosynthesis takes place 24-hours a day and keeps pH as stable as can be managed. If pH levels are seen to be constantly below the desired level and alkalinity is within the proper range, increasing the circulation of water near the aquarium surface will often produce positive results; this practice increases the rate of gas exchange and encourages entrained CO2 to exit the aquarium before it has a chance to form the weak acids responsible for low pH and depletion of alkalinity.
Instructions and Guidelines
pH is always lowest a few hours after the main lights have turned off for the evening, and is highest a few hours after lights have been burning during the day. Adjust pH to remain with a range of 8.1 - 8.5 at all times. Before adjusting pH, ensure that the alkalinity in the aquarium is within a range of 7 - 12 dKH (2.5 - 4.3 meq/L). Determine the pH in the aquarium using an accurate test kit or recently-calibrated pH meter before using Brightwell Aquatics pH+. If the alkalinity is below the desired level, adjust this first and then allow 24-hours to elapse before re-testing pH, then add pH+ as directed below. [Alkalinity may be increased by using a buffer-type product according to the directions; again, an accurate test kit (for measuring alkalinity) should be used whenever bringing about a significant change to the alkalinity. Brightwell Aquatics’ Alkalin8.3 or Alkalin8.3-P (powder) are two buffer-type products that may be used for this purpose.]
Add this product at the maximum dosage of 5 ml per 20 US-gallons per 24-hours at the same time each day. pH will generally stabilize within 2 hours following product use, however livestock should not be subjected to a change in pH of more than 0.2 per 24-hour period, so do not overdose pH+. Repeat as needed to attain desired pH value. It is recommended that pH be maintained within a range of +/-0.2 at all times.
Caution: Contains carbonate salts; harmful if swallowed. If swallowed: give water, get medical attention. May cause eye or skin irritation. If in eyes, flush with water for 15 minutes, get medical attention. If on skin, wash thoroughly with water. Keep out of reach of children. Not for human consumption.
Carbonate (min) 1,497mg/oz. (50,633 ppm)
Purified water, inorganic Carbonate salts
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.